SuprSheen® Ultra Guard is a silane based sealer to deliver the ultimate final seal for polished concrete. This product is Chemforce Stain Protector product.
SuprSheen Ultra Guard is suitable for most types of porous building materials, including natural stone, brick, terracotta, concrete paving and polished concrete. SuprSheen Ultra Guard is suitable for indoor and outdoor surfaces.
HOW TO USE
Preparation:
TEST PRODUCT ON A SMALL, INCONSPICUOUS AREA FIRST. Allow a 24-hour cure time to determine the ease of application and desired results.
Surface must be clean, dry and free of any residues.
Apply when surface temperature is between 5-35°C (40 – 95°F).
DO NOT thin product.
Application – Dense / Polished Surfaces:
SuprSheen Ultra Guard should be applied to polished surfaces with a microfibre / lamb’s wool applicator or brush or cloth, so the sealer is wiped over the surface. If the product is sprayed onto a polished surface it may bead up and leave parts of the surface untreated. Spraying is not recommended for polished surfaces.
The product should be left to dwell for as long as possible after each application, to give the product plenty of time to penetrate.
Leave to penetrate for at least 10 minutes.
Generously apply SuprSheen Ultra Guard using brush or microfiber / wool applicator. Very porous surfaces should have a mirror like wet look for at least 3-5 seconds. Avoid contact with surrounding areas.
Before it dries on the surface, apply a second generous coat.
Total application rate (for both coats combine) is one litre per 4 to 20 sqm (one gallon per 160 to 800 sq. ft) depending on surface absorption.
After minimum 10 minutes but, before the second coat dries, thoroughly polish the surface with clean, white absorbent cotton or microfiber towels (or similar) to remove ALL product residue. If residue has begun to dry, moistening a cloth with SuprSheen Ultra Guard to ease removal.
Use an organic solvent e.g. alcohol or mineral spirits to clean equipment.
Avoid moisture contact with the surface for six hours after application.
NOTE: Sealer will NOT prevent surface etching, scuff marks or mechanical wear and may lighten or darken some surfaces. SuprSheen Ultra Guard repels water and oil, but not solvents, so solvent based materials, such as marking pen ink can still stain the treated surface, but will penetrate less, and be easier to remove. All spills should be cleaned up immediately to minimize absorption.
Shelf Life and Storage Guidelines
Best within 3 years of manufacture.
Keep container tightly sealed, in a well-ventilated place, at 2 – 30° Celsius (36 – 85° Fahrenheit).
Pack Sizes – 1L (1.06Q); 5L (1.3 gallon), 20L (5.3 gallon)
Yield – 4 to 25 sq m. per litre (160 – 1000 sq. ft. per Gallon).
Technical Data
High Active Content: >40%.
SG: ~0.89
VOCs >300g/L
Weight: 1L (1.06Q) = 0.93Kg (2Lb.); 5L (1.3G) = 4.8Kg (10.6Lb), 20L (5.3G) = 19Kg (41.9Lb),
Country of Manufacture – Australia
Reviews
There are no reviews yet.